Glue for wallpapers non-woven fabric (TNT) from the German manufacturer AS Creation. Offers good coverage with excellent adhesion when applied correctly. Easy to prepare (you just need to add water and stir) and to install (the wall is glued).
-
Properties:
Made with high quality methylcellulose and starch. Resistant to lime and cement. Dries without leaving stains.
- Surface preparation:
The surface to be wallpapered must be dry, clean, firm, smooth, and slightly porous. Any cracks or holes must be sealed with putty. If the wall is very porous, it is recommended to apply a coat of glue over the entire surface using the pre-gluing water ratio according to the preparation instructions (8 liters of water per package) and let it dry for a day. Then, proceed normally with the installation.
| USE |
Liters of water per package |
Package enough for: |
| Pre-glued |
8L |
60 m2 |
| TNT wallpaper |
5L |
35 m2 |
| Fiberglass |
4L |
30 m2 |
- Preparing the mixture:
Pour cold water into a clean bucket based on what is established in the table and add the contents of the package, stirring continuously. Wait 5 minutes and stir the mixture well again. Your glue AS Creation for wallpapers is now ready for use.
- Yield: 5-7 rolls.
Key points:
- All the wallpapers from ALF&mabi are non-woven type, therefore, they are suitable for this type of glue.
- The glue should go to the wall (and not to the paper)
Make sure to clean off any excess glue that remains on the paper during installation before the glue dries.
